Wix Japan Community.png
  • HOME

  • ABOUT

  • LOCATION

  • HOST

  • EVENT

    • EVENTS LIST
    • EVENT GALLERY
  • CONTACT

  • FORUM

  • MEMBERS

  • BLOG

  • More...

    Use tab to navigate through the menu items.
    To see this working, head to your live site.
    • Categories
    • All Posts
    • My Posts
    Leading Coating
    Jul 28

    Failure Analysis of Industrial Furnace

    in 新機能リクエスト

    Each reversing valve is equipped with a pneumatic triple, which should be regularly refueled, slag cleaned, and drained. When refueling, first close the front hand valve of the pneumatic triple piece, and then remove the oil cup to add oil. The oil volume of the oil cup should not exceed the full scale. The oil is the atomized oil specified by the pneumatic triplet, and can also be replaced by 32# turbine hydraulic oil. Vacuum Heat Treatment of LD Steel Hexagonal Cold Heading DieThe atomization speed of the oil should be adjusted to 3 to 5 days to atomize a cup of oil. When refueling, if necessary, slag removal and drainage can be carried out together. If the pneumatic triplet does not atomize oil, the triplet should be repaired or replaced in time.Gear Process Vacuum Heat Treatment Furnace When the reversing system fails and alarms, find out the fault point according to the alarm indicator displayed on the control cabinet, and carry out timely treatment after on-site inspection and confirmation to restore the normal operation of the reversing valve. If the air pipe bursts or falls off, close the compressed air supply valve of the reversing valve and replace the corresponding air pipe immediately. Aerospace material vacuum heat treatment furnaceIf the limit switch is loose and cannot contact the circular iron sheet on the valve stem, the rotation angle of the limit switch can be adjusted immediately to ensure the normal contact between the reversing valve plate and the limit switch contact wheel when it is at the front and rear limit positions. If it does not belong to the above 1), 2) cause the alarm, check whether the solenoid valve operates normally, and replace the solenoid valve if necessary. If it does not belong to the above 1), 2), 3) fault alarm, check whether the cylinder is leaking, and whether the wiring of the limit switch and the solenoid valve is normal.

    0 comments
    0
    Comments
    0 comments
    Similar Posts
    • Introduction of induction furnace
    • What does the aging furnace do?
    • the control design of the electric furnace

    STAY IN TOUCH

    お問い合わせ
    LINKS
    • HOME
    • ABOUT
    • LOCATION
    • HOST
    • EVENT
      • EVENTS LIST
      • EVENT GALLERY
    • CONTACT
    • FORUM
    • MEMBERS
    • BLOG
    CONTACT
    academywx@gmail.com
    SOCIAL
    • White Facebook Icon
    • White Twitter Icon
    〒460-0002
    愛知県名古屋市中区丸の内3-20-29
    ブレドール丸の内902号
    ​
    〒904-0116
    沖縄県中頭郡北谷町北谷2-11-14
    La Costa Hamby 301号

    Success! Message received.

    59813981_395702594351241_439128578160852
    elitusdesign-logo2019b.png

    © 2017-2020. Wix Community Japan. Elitus, K.K. All rights reserved.